Honda VTR1000F Service Manual page 329

SIDE STAND SWITCH
INSPECTION
Remove the seat (page 2-2).
Disconnect the side stand switch 3P (green) connec-
tor.
Check for continuity between the connector termi-
nals in each side stand poslton.
Continuity should exist between the color coded
wires as follows:
~
Position
G/W
V/BI
G
Lowered ("- )
Retracted (" 2
REMOVAL/INSTALLATION
Remove the seat (page 2-2).
Disconnect the side stand switch 3P (green) connec-
tor.
Remove the side stand switch bolt and switch.
Install the side stand switch by aligning the switch
pin with the side stand hole and the switch groove
with the bracket pin.
Install the side stand switch bolt and tighten it.
TORQUE: 10 N·m (1.0 kgf·m, 7lbf·ft)
Install the removed parts.
NOTE:
Route the speed sensor wire properly (page 1-18).
LOW FUEL INDICATOR/FUEL RESERVE SENSOR
SYSTEM INSPECTION
Remove the seat (page 2-2).
Low fuel indicator does not go off
Disconnect the fuel reserve sensor 2P (white) con-
nector.
Turn the ignition switch ON and check the low fuel
indicator.
If the indicator does not come on, replace the fuel
reserve sensor.
If the indicator comes on, check for short circuit in
brown/black wire.
LIGHTS/METERS/SWITCHES
19-17