Primary Drive Gear Installation - Honda VTR1000F Service Manual

Remove the water pump driven sprocket and drive
chain.
INSTALLATION
Apply molybdenum oil solution to the water pump
driven sprocket shaft.
Install the water pump drive chain over the drive
and driven sprockets.
Install the driven sprocket shaft into the crankcase.
Install the damper springs into the primary drive
gear grooves.
Miii
'98
only
Install the friction spring onto the primary drive
gear with the concaved side toward the sub-gear.
Apply molybdenum disulfide grease to the primary
drive gear and sub-gear sliding surfaces.
Install the sub-gear onto the primary drive gear
boss so that the sub-gear tabs are positioned
against the damper spring and holes are aligned.
Install the primary drive gear assembly and ignition
pulse generator rotor by aligning the wide grooves
with the wide tooth.
Apply oil to the threads and seating surface of the
primary drive gear bolt.
Install the special washer and primary drive gear
bolt.
Install the clutch outer (page 9-17).
Install the special tool between the primary drive
and driven gears as shown and tighten the primary
drive gear bolt.
TOOL:
Gear holder
07724-0010100
TORQUE: 88 N·m (9.0 kgf·m , 65 Ibf·ft)
Assemble the clutch (page 9-17).
Revised: December 1999, '98-2000 VTR1000F
©1999 American Honda Motor Co., Inc - All Rights Reserved
MSV 8712 (9911)
CLUTCH/GEARSHIFT LINKAGE
HOLES
PRIMARY DRIVE
GEAR
9·23