Honda VTR1000F Service Manual page 394

DIAGNOSTIC CODE INDICATION
Remove the front fairing (page 2-3).
Disconnect the ignition pulse generator 2P (white)
connector.
Connect the inspection adaptor to the wire harness
side connector.
Connect the red clip of the adaptor to the 12 V bat-
tery positive (+) terminal and green clip to the neg-
ative (-) terminal.
TOOL:
Inspection adaptor 07XMZ-MBW0100
Turn the ignition switch ON with the properly regis-
tered key.
The immobilizer indicator will come on for approx.
ten seconds then it will start blinking to indicate the
diagnostic code if the system is abnormal.
The blinking frequency is repeated.
NOTE:
The immobilizer indicator remains on when the
system is normal. (The system is in the normal
mode and the diagnostic code does not appear.)
DIAGNOSTIC CODE
VTR1000F
(1)
ADDENDUM
INSPECTION ADAPTOR
12VBATIERY
IGNITION PULSE GENERATOR CONNECTOR
IMMOBILIZER INDICATOR
When the system (lCM) enters the diagnostic mode from the normal mode:
BLINKING PATTERN SYMPTOM PROBLEM
PROCEDURE
~~F:~~
• •
~
Ignition control
module (lCM) data
Faulty ICM Replace the ICM
10 sec.
is abnormal.
JUUlJlfl
Code signals cannot
Faulty receiver or
Follow the trouble-
shooting (page 24-
send or receive. wire harness
39).
JLfUUUL Identification code Keep the other
is disagree vehicle's transpon-
Jamming by the der key away from
other transponder the immobilizer
JLJlJ1J1Jl
Secret code is
receiver more than
disagree
50 mm (2.0 in).
24-35