Rear Brake Caliper Disassembly - Honda VTR1000F Service Manual

Assemble the caliper body halves.
Apply locking agent to the caliper assembly bolt
threads.
Install and tighten the assembly bolts.
TORQUE: 32 N·m (3.3 kgf·m ,24 Ibf·ft)
Install the brake pads (page 15-5).
Connect the brake hose to the brake caliper with
the oil bolt and new sealing washers, and tighten
the oil bolt.
TORQUE: 34 N·m (3.5 kgf·m ,25 Ibf·ft)
Fill and bleed the front brake hydraulic system
(page 14-3).
REAR BRAKE CALIPER
CAUTION:
Avoid spilling fluid
on
painted, plastic
or
rubber
parts. Place
a
rag over these parts whenever the
system is serviced.
DISASSEMBLY
Drain the brake fluid from the rear brake hydraulic
system (page 15-3).
Disconnect the brake hose from the rear brake cali-
per by removing the oil bolt and sealing washers.
Remove the rear brake pads (page 15-6).
Remove the rear brake caliper from the bracket.
HYDRAULIC BRAKE
15-19