Left Crankcase Cover Removal; Stator Replacement; Alternator/Starter Clutch - Honda VTR1000F Service Manual

ALTERNATOR/STARTER CLUTCH
ALTERNATOR STATOR
10-2
LEFT CRANKCASE COVER REMOVAL
Remove the following:
- seat (page
2-2)
-front fairing (page
2-3)
Disconnect the alternator 3P (white) connector.
Remove the three bolts and clutch slave cylinder
from the drive sprocket cover.
Remove the eight bolts and left crankcase cover.
Temporarily install the clutch slave cylinder.
Remove the dowel pins and gasket.
STATOR REPLACEMENT
Remove the four bolts, wire clamp, grommet and
stator from the left crankcase cover.
Install a new stator onto the left crankcase cover.
Apply sealant to the grommet seating surface and
install it into the cover groove properly.
Install the wire clamp.
Tighten the four bolts.
TORQUE: 12 N·m (1.2 kgf·m, 9Ibf·ft)