Drive Chain Sprocket Inspection; Drive Chain Replacement - Honda VTR1000F Service Manual

MAINTENANCE
3-16
SPROCKET INSPECTION
Inspect the drive and driven sprocket teeth for dam-
age or wear. Replace if necessary.
Never use a worn chain on new sprockets. Both
chain and sprockets must be in good condition, or
the new replacement parts will wear rapidly.
Check the attachment bolt and nuts on the drive
and driven sprockets. If any are loose, torque them.
REPLACEMENT
This motorcycle uses a drive chain with a staked
master link.
Loosen the drive chain.
Assemble the special tool.
TOOL:
Drive chain tool set
07HMH-MR10103
NOTE:
When using the special tool, follow the manufac-
turer's instruction.
Locate the crimped pin ends ofthe master link from
the outside of the chain and remove the link with
the drive chain tool set.
Remove the drive chain.
WORN
DRIVE CHAIN CUTTER
MASTER LINK
DRIVE CHAIN CUTTER