Float Level Inspection - Honda VTR1000F Service Manual

FLOAT CHAMBER
Install the pilot screw and return them to their origi-
nal position as noted during removal.
Perform the pilot screw adjustment if new pilot
screw is installed.
CAUTION:
Damage to the pilot screw seat will occur if the pi-
lot screw is tightened against the seat.
Install the needle jet holder, main jet and slow jet.
CAUTION:
Handle the jets with care. They can easily be
scored or scratched.
Hang the float valve onto the float arm lip.
Install the float valve, float and float pin.
FLOAT LEVEL INSPECTION
With the float valve seated and the float arm just
touching the valve, measure the float level with the
float level gauge.
TOOL:
Float level gauge 07401-0010000
FLOAT LEVEL: 16.6
±
0.5 mm (0.65
±
0.02 in)
The float cannot be adjusted.
Replace the float assembly if the float level is out of
specification.
Install a new O-ring into the float chamber groove.
Install the float chamber and tighten the three
screws.
FUEL SYSTEM
5-11