Honda VTR1000F Service Manual page 122

Install the dowel pins and guide plate.
Install a new gasket, drive sprocket cover and
clamp, and tighten the two bolts.
Install the dowel pins and a new gasket (page 9-11).
Install the clutch slave cylinder and tighten the
bolts.
Release the clutch lever from the handlebar.
Install the gearshift arm (page 9-22).
Connect the starter motor cable.
Install and tighten the terminal nut.
TORQUE: 10 N·m (1.0 kgf·m, 7Ibf·ft)
Install the rubber cap securely.
Route the wires properly (page 1-18).
Connect the following:
-pulse generator 2P (white) connector
ENGINE REMOVAL/INSTALLATION
7-11