Shock Arm Pivot Bearing Replacement - Honda VTR1000F Service Manual

Press in the
Apply molybdenum disulfide grease to the needle
bearing with the
rollers of new bearings.
marking side
Carefully press the needle bearing in the shock link
facing up.
pivot until the depth from the shock link outer sur-
face is 5.2-5.7 mm (0.20-0.22 in), using the spe-
cial tool.
TOOLS:
Driver 07749-0010000
Attachment,24 x 26 mm 07746-0010700
Pilot, 17 mm 07746-0040400
Apply molybdenum disulfide grease to new dust
seal lips and install them into the shock link pivots
until they are seated.
Install the pivot collars.
SHOCK ARM PIVOT BEARING
REPLACEMENT
Remove the pivot collar and dust seals.
Press the needle bearings out of the shock arm piv-
ot using the special tool.
TOOL:
Pin driver
07GMD-KT80100
REAR WHEEL/SUSPENSION
ATIACHMENT
....
- ~
PILOT '"
14-13