Honda VTR1000F Service Manual page 255

Apply molybdenum disulfide grease to new dust
seal lips and install them into the swingarm pivots.
Install the pivot collars.
Install the brake hose clamps if removed, aligning
the boss with the hole in the swingarm.
Install and tighten new screws.
TORQUE:
4 N·m (0.43 kgf·m ,3.1 Ibf·ft)
Install the drive chain slider if removed, aligning
the hole with the boss of the swingarm.
Install and tighten new bolts.
TORQUE:
9 N·m (0.9 kgf·m , 6.5 Ibf·ft)
INSTALLATION
Install the swingarm onto the engine and insert the
pivot bolt through the right driver footpeg bracket,
swingarm, engine and left driver footpeg bracket.
Install the swingarm pivot nut.
Install the left driver footpeg bracket onto the shock
link bracket and tighten the socket bolt.
REAR WHEEL/SUSPENSION
PIVOT NUT
SOCKET BOLT
14-19