Coolant Replacement; Radiator Cap/System Pressure Inspection - Honda VTR1000F Service Manual

COOLING SYSTEM
RADIATOR CAP/SYSTEM PRESSURE
INSPECTION
Before installing
Pressure test the radiator cap using the tester.
the cap in the
Replace the radiator cap if it does not hold pressure,
tester, wet the
or if relief pressure is too high or too low. It must
sealing surfaces.
hold specified pressure for at least 6 seconds.
RADIATOR CAP RELIEF PRESSURE:
108-137 kPa (1.1-1.4 kgf/cm2, 16-20 psi)
Pressure the radiator, engine and hoses using the
tester, and check for leaks.
CAUTION:
Excessive pressure can damage the cooling sys-
tem components. Do not exceed 137 kPa (1.4 kgf/
cm2, 20 psi).
Repair or replace components if the system will not
hold specified pressure for at least 6 seconds.
COOLANT REPLACEMENT
PREPARATION
6-4
' * 14*"' ' '
• Radiator coolant is toxic. Keep
it
away from eyes,
mouth, skin and clothes.
-If any coolant gets in your eyes, rinse them
with water and consult a doctor immediately.
-If any coolant is swallowed, induce vomiting,
gargle and consult a physician immediately.
-If any coolant gets on
your skin or clothes,
rinse thoroughly with plenty of water.
• KEEP OUT OF REACH OF CHILDREN.
NOTE:
• The effectiveness of coolant decreases with the
accumulation of rust or if there is a change in the
mixing proportion during usage. Therefore, for
best performance change the coolant regularly
as specified in the maintenance schedule.
• Mix only distilled, low mineral water with the
antifreeze.
RECOMMENDED MIXTURE:
50-50 (Distilled water and antifreeze)
ANTIFREEZE
SOLUTION
(ETHYLENE
GLYCOL BASE
SOLUTION)
LOW MINERAL OR
DISTILLED WATER
COOLANT