LIGHTS/METERS/SWITCHES
POSITION LIGHT (Except U type)
BULB REPLACEMENT
Remove the two screws and position light lens.
Pull the position light bulb out of the socket and
replace it with a new
one.
Make sure that the seal rubber is installed in posi-
tion and is in good condition, and replace it with
new one if necessary.
Install the position light lens and tighten the two
screws.
REPLACEMENT
Remove the three bolts and the instrument assem-
bly from the stay (page 19-6).
Disconnect the position light connector.
Remove the two screwS and the position light.
Install the position light in the reverse order of re-
moval.
TURN SIGNAL LIGHT
BULB REPLACEMENT
Remove the screw and turn signal light lens.
19-4
/
LENS