Rear Wheel Disassembly; Rear Wheel Bearing; Rear Wheel Driven Sprocket - Honda VTR1000F Service Manual

REAR WHEEL/SUSPENSION
WHEEL
Check the rim runout by placing the wheel in a
truing stand. Spin the wheel slowly and read the
runout using a dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS: RADIAL:
2.0 mm (0.08 in)
AXIAL: 2.0 mm (0.08 in)
WHEEL BEARING
Turn the inner race of each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the hub.
Replace the wheel
Remove and discard the bearings if the races do
bearings in pairs.
not turn smoothly and quietly, or if they fit loosely
in the hub.
14-4
DRIVEN SPROCKET
Check the condition of the driven sprocket teeth.
Replace the sprocket if worn or damaged.
NOTE:
• If the driven sprocket requires replacement, in-
spect the drive chain and drive sprocket.
• Never install a new drive chain on a worn sprock-
et or a worn chain on new sprockets. Both chain
and sprocket must be in good condition, or the
replacement chain or sprocket will wear rapidly.
DISASSEMBLY
Remove the right dust seal.
Remove the bolts and brake disc.
WHEEL BEARING
OK NO GOOD