Turn Signal Light Removal/Installation; Brake/Taillight Bulb Replacement - Honda VTR1000F Service Manual

While pushing the bulb in, turn it counterclockwise
to remove it, and repalce it with a new one.
Make sure that the seal rubber is installed in posi-
tion and is in good condition, and replace it with
new one if necessary.
Install the lens, aligning the hook with the tab of the
turn signal light, and tighten the screw.
REMOVAL/INSTALLATION
Rear turn signal light: Remove the seat (page 2-2).
Disconnect the turn signal light connectors.
Remove the nut, setting plate and the turn signal
light.
Install the turn signal light in the reverse order of
removal.
BRAKE/TAILLIGHT
BULB REPLACEMENT
Remove the seat (page 2-2).
Turn the socket counterclockwise and remove it
from the brake/taillight.
Pull the brake/taillight bulb out of the socket and re-
place it with a new one.
Make sure
th~t the seal
rubber is installed in posi-
tion and is in good condition, and replace it with
new one if ncessary.
Install the socket by turning it clockwise.
Install the seat (page 2-2).
LIGHTS/METERS/SWITCHES
AL UGHTBU LB
19-5