Crankcase Separation - Honda VTR1000F Service Manual

CRANKCASE SEPARATION
Remove the following:
-engine (section 7)
-cylinder head (section 8)
-clutch, gearshift linkage, primary drive
gear (section 9)
-flywheel (section 10)
-starter motor (section 18)
-oil pump (section 4)
-cam chain tensioners
-cam chain guides
- starter reduction gear and shaft
-cam chains
Loosen the two 6 mm bolts, nine 8 mm bolts and 10
mm bolt in a crisscross pattern in 2 or 3 steps and
remove them from the upper crankcase.
Place the engine with the upper side down.
Loosen the two 6 mm bolts, six 8 mm bolts and
eight 10 mm bolt in a crisscross pattern in 2 or 3
steps and remove them from the lower crankcase.
Separate the lower crankcase from the upper crank-
case.
CRANKCASE/TRANSMISSION
11-3