Brake Caliper Assembly - Honda MBX50 Workshop Manual

�HONDA
� MBX50· MBXSO
ASSEMBLY
Wash all the removed parts. Coat the piston and
dust seals with silicone grease.
Lubricate the inside diameter of the caliper cylinders
with brake fluid and install the pistons with the
concave end on the brake pad side.
NOTE
Install the pistons with the end 3-5 mm
(1/8-1/5 in) projecting above the caliper.
Wipe excess brake fluid off the caliper with a clean
cloth.
Lubricate the inside of the pin boots with silicone
grease and install them in the caliper.
Install the pad spring and pads with the pin bolts.
NOTE
If the brake pad is dirty, clean with sand
paper.
Loosely tighten the pin bolts.
Make sure that the pin bolts are inserted through
the holes in the brake pad.
HYDRAULIC BRAKE
(1) PISTONS
(1) PIN BOOTS
(1) PADS
a
12 ...