Rear Wheel - Honda CB160 Shop Manual

4. 13 REAR WHEEL
Fig. 4. 81 Disassembling rear wheel
4. 13 Rear wheel
A. Description of rear wheel
The rear wheel consists of the 6302
R
ball bearing,
aluminum cast rear wheel hub with brake drum, and
the brake panel.
It
is equipped with the single cam
rear brake panel through the panel side collar on the
right side. At the left side of the wheel hub, the
hub and the final driven sprocket are held with the
sprocket mounting nut. This unit is mounted on the
rear fork through the rear side caller at the rear axle.
(Refer to Fig. 4. 81)
B. Disassembly
l . Tools required for disassembly and assembly of
the rear wheel. (Refer to Fig. 4. 82)
2. Following Section 4. 7 B, remove the rear brake
cable.
3. By removing the drive chain joint, separate the
chain. (Refer to Fig. 4. 83)
4. Loosen the rear brake panel limit bolt, and remove
the rear brake limit arm from the panel.
5. Straighten the 30 X 34 cotter pin and remove it
from the axle.
6. Loosen the rear wheel axle nut and extract the
rear wheel axle.
Fig. 4. 82 Tools required for disassembly and assembly
of rear wheel
Fig. 4. 83 Removing drive chain
77