Construction; Clutch Reassembly; Crankcase Cover !Left; Disassembly - Honda CB450 1968 Service Manual

3. ENGINE
@
Fig . 3.
88
Clutch spring tension measuring
Fig. 3. 89 Neutral switch and generato r c.ord clomp
CD
Neut ral switch
®
Generator cord
Fig. 3. 90
Remove the left crankcase cover
(D
Starting motor sprocket
®
Generator ro tor
Fig. 3. 91 Removing the A C generator rotor
CD
Generator rotor
®
T-hondle gererator rotor puller
K. Clutch Reassembly
Reassemble the clutch in the reverse order of
disassembly.
NOTE:
a. Exerc ise care when installing the pump rod,
installing pump rod in reverse will render the
pump inoperative .
(Fig. 3. 82, 3. 83)
b. The oil pump lock washer should be replac ed
with a new item.
c. Before installing the oil pump, check to make
sure that the 8
X
15 0 ring install around the
pin at the pump is not missin g or damaged.
(Fig. 3. 83)
d. Exercise care not to damage the surfaces
of the clutc h plate. (fig. 3. 80)
3. 4 Crankcase Cover (left)
A. Construction
Left crankcase cover houses the generator and
the starting cl\)tch. The generator is not shielded
from the lubricant and, therefore, the oi l seal is not
used, thus simplifying construction.
B. Disassembly
1. Remove the neutral switch. (
Fig. 3. 89)
2. Remove the left side crankcase cover.
(Fig,
3. 90)
Remove the generator stator from the left
crankcase cover by loosening the mounting nut.
3. Remove the generator rotor by using a
generator rotor puller. (Fig. 3. 91)