Left Crankcase Cover - Honda CBR650F Service Manual

dummyhead dummyhead

LEFT CRANKCASE COVER

REMOVAL/INSTALLATION
Support the motorcycle in an upright position on a level
surface.
Lift the fuel tank and support it (page 3-4).
Remove the under cowl (page 2-11) (CBR650F/FA
only).
Disconnect the alternator 3P (Gray) connector [1].
Release the alternator wire clip [2] (CBR650F/FA only).
Release the alternator wire clip [1].
Remove the alternator wire out of the frame.
• Place a clean oil pan under the engine because
engine oil will flow out when removing the left
crankcase cover. Add the recommended engine oil
to the specified level after installation (page 3-9).
Remove the following:
– Left crankcase cover bolts [1]
– Under cowl stay (CBR650F/FA only) [2]
– Left crankcase cover [3]
• The left crankcase cover (stator) is magnetically
attracted to the flywheel, be careful during removal
and installation.
Remove the dowel pins [1].
Clean any sealant off from the alternator cover mating
Be careful not to
surfaces.
damage the mating
surfaces.
CBR650FA:shown:
[1]
[1]
[2] (CBR650F/FA only)
[1]
ALTERNATOR
[2] (CBR650F/FA only)
[3]
[1]
12-3