Ignition Coil Installation - Club Car FE350 2005 Maintenance Service Supplement

12
ELECTRICAL COMPONENTS
Ignition Coil Removal, Continued:
2
Figure 12-26 Stiffener Removal
10
Figure 12-27 Fan Housing Removal

Ignition Coil Installation

NOTE: If a new ignition coil is being installed, the spark plug cap, gasket, protector tube and grommet
must be removed from the old coil and installed on the new coil. See steps 1 through 8 for pro-
cedures to remove and install these existing parts.
If the existing ignition coil will be remounted, proceed to step 9.
1. Remove the rubber gasket (1) on the plug cap (2) by rolling back the gasket onto the spark plug wire
(Figure 12-29, Page 12-27).
2. Remove the cap (2) from the wire by turning the cap counterclockwise three or four revolutions while
gently pulling it off the wire.
Page 12-26 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
3
4
1
9
6
Remove
8
12
5
11
Figure 12-28 Ignition Coil Removal
Ignition Coil
10