Club Car FE350 2005 Maintenance Service Supplement page 189

TORQUE CONVERTER
12. Install the 1/4-20 bolts and washers (2) and tighten them to 10 ft-lb (13 N·m) (Figure 17-5, Page 17-6).
See following NOTE.
NOTE: Make sure there is at least a (minimum) gap of 0.020 inch (0.51 mm) between each end of the
mounting pin and the mounting bolt.
13. Install three drive button take-up springs.
13.1. Install each spring on right-hand side of the three button mounting posts (when looking into the
interior of the clutch drive hub, and with the rib at a twelve o'clock position) as shown (Figure 17-15,
Page 17-11).
14. Compress each take-up spring and install the drive button over the rib and take-up spring (Figure 17-8,
Page 17-8).
15. Install a no. 10-24 button retaining screw with flat washer through each button and into the rib. Tighten
the screws to 34 in-lb (3.8 N·m) (Figure 17-9, Page 17-8).
16. Install the thrust washer (11) onto the moveable face assembly (Figure 17-5, Page 17-6).
17. Install the hub assembly (8) on the moveable face assembly and align the match marks made before dis-
assembling the clutch. Press the hub assembly on by hand.
18. Replace the three plastic plugs (22) into the hole protectors (Figure 17-5, Page 17-6).
DRIVE BUTTON TAKE-UP
SPRING PROPERLY INSTALLED
Figure 17-15 Correct Orientation of Drive Button Take-up Springs
2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
17
Drive Clutch
Page 17-11