Drive Belt - Club Car FE350 2005 Maintenance Service Supplement

17
TORQUE CONVERTER
Troubleshooting, Continued:
2. Inspect the driven clutch for dirt and dust buildup on its component parts. Clean the driven clutch with
water to remove any dust or dirt, then drive the vehicle and check for proper operation.
3. If cleaning the driven clutch does not solve the problem, disassemble and thoroughly clean all parts of
the drive clutch. Be sure to clean the plastic drive buttons (10) (Figure 17-5, Page 17-6).
TORQUE CONVERTER TOOL KIT
DRIVE CLUTCH HUB PULLER
(CCI P/N 1014497)

DRIVE BELT

See General Warning, Section 10, Page 10-1.
The drive belt should be inspected semiannually for wear and (or) glazing. If it is excessively worn, frayed, or
glazed, replace the belt.
As the drive belt wears, the engine RPM will increase to compensate for the change in torque converter ratio.
This will keep the vehicle's maximum ground speed correct. See Section 2 – Vehicle Specifications in the
appropriate maintenance and service manual.
Page 17-2 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
(CCI P/N 1014510)
DRIVE CLUTCH HOLDER TOOL
(CCI P/N 1015524)
Figure 17-1 Torque Converter Tool Kit
DRIVEN CLUTCH CAM PULLER
(CCI P/N 1014508)
Drive Belt
DRIVEN CLUTCH
CAM PRESS TOOL
(CCI P/N 101809101)
DRIVEN CLUTCH
PULLER PLUG
(CCI P/N 1014507)
DRIVE
CLUTCH PULLER
(CCI P/N 1014496)