Club Car FE350 2005 Maintenance Service Supplement page 173

UNITIZED TRANSAXLE
24. Connect the Forward/Reverse shifter and bracket to the transaxle.
24.1. Install the three screws (2) securing the Forward/Reverse shifter cable bracket (1) to the transaxle
and tighten them to 135 in-lb (15.3 N·m) (Figure 16-35, Page 16-15).
24.2. Place the woodruff key (10) on the shifter shaft (9).
24.3. Place the shifter lever (6) (aligned with the woodruff key) onto the Forward/Reverse shaft (9).
24.4. Install the nut (3), washer (4), and bolt (7) on the Forward/Reverse shifter lever and tighten to 23
in lb (4.1 N·m).
25. Position the shifter cable in the shifter cable mounting bracket on the transaxle and tighten the mounting
nuts to 22 ft-lb (29.8 N·m). Connect shifter cable rod end to the shifter arm (Figure 16-46, Page 16-19).
26. Attach the ground wire to the mounting screw on the oil filler tube mounting bracket and tighten to 50 in-
lb (5.7 N·m) (Figure 16-47, Page 16-19).
TOP VIEW
Pull spring release back to
NUTS
connect shifter cable to lever.
Figure 16-46 Connect Shifter Cable
27. Connect accelerator cable to actuator cam in the electrical box. Position the accelerator cable in mount-
ing slot in the wall of the electrical box and tighten mounting nuts to 18 in-lb (2.0 N·m) (Figure 16-48,
Page 16-19). Install electrical box cover and tighten mounting screw.
28. Remove the 1/4-inch bolt from the fuel line and connect the fuel line to the carburetor and secure with
a hose clamp (Figure 16-49, Page 16-19).
TOP VIEW
Figure 16-48 Connect Cable to Cam
RETAINING NUTS
2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
Unitized Transaxle Installation
Figure 16-47 Engine Ground
Figure 16-49 Connect Fuel Line
16
Page 16-19