Oil Viscosity; Fueling Instructions - Club Car FE350 2005 Maintenance Service Supplement

PERIODIC MAINTENANCE

OIL VISCOSITY

Choose the viscosity according to the temperature as indicated by the oil viscosity chart (Figure 10-5,
Page 10-7). See following NOTE.
-20 °C -10 °C 0 °C
SAE 10W-30/SAE 10W-40
SAE 5W-20
-4 °C 14 °C 32 °C
Figure 10-5 Oil Viscosity Chart
NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level
more frequently when using multi-grade oils.

FUELING INSTRUCTIONS

See General Warning on page 10-1.
ý
DANGER
• Turn key switch to the OFF position before fueling.
• Do not pour fuel into the fuel tank when the engine is hot or while it is running.
• To avoid electric arc caused by static electricity, the fuel storage/pumping device must be
grounded. If the pump is not grounded, the vehicle must be grounded to the pump before and
during the fueling operation.
• If the vehicle has an all-weather enclosure installed, the fuel tank must be properly vented as
shown (Figure 10-4, Page 10-6).
• To avoid the possibility of fire, clean up any spilled fuel before operating the vehicle.
ý
CAUTION
• To allow for expansion, do not fill higher than one inch (2.54 cm) from the top of the fuel tank.
Avoid spilling fuel.
NOTE: Whenever possible, avoid using oxygenated fuels and fuels that are blended with alcohol. Vehicles
to be stored for extended periods should be prepared for storage as instructed. See Preparing the
Vehicle for Extended Storage in Section 3 of the appropriate maintenance and service man-
ual.
10 °C 20 °C 30 °C 40 °C
SAE 40
SAE 30
50 °C 68 °C 86 °C 104 °C
2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
10
Fueling Instructions
Page 10-7