Solenoid - Club Car FE350 2005 Maintenance Service Supplement

12
ELECTRICAL COMPONENTS
Key Switch Installation
1. Reverse removal procedures to install key switch in the dash. Connect wires to key switch. See the
appropriate wiring diagram in Section 11 – Troubleshooting and Electrical System, starting on
page 11-6. Coat the connectors with Battery Terminal Protector Spray (CCI P/N 1014305) to prevent cor-
rosion. Be sure that key switch terminals cannot touch the frame and that panel is properly seated and
snapped in place.
2. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.

SOLENOID

See General Warning, Section 10, Page 10-1.
Testing the Solenoid
See Test Procedure 7, Section 11, Page 11-21.
Solenoid Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Remove electrical component box cover (Figure 12-18, Page 12-17).
3. Disconnect all the wires from the solenoid.
4. Remove the two screws securing the solenoid in place.
5. Remove the solenoid.
Page 12-14 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
3
Figure 12-17 Center Dash Panel Removal
Solenoid
2
1