Fuse; Kill Limit Switch - Club Car FE350 2005 Maintenance Service Supplement

12
ELECTRICAL COMPONENTS
Solenoid Installation, Continued:
3. Tighten the hex nuts on the large solenoid posts to 60 in-lb (6.8 N·m). Tighten the nuts on the small sole-
noid posts to 22 in-lb (2.5 N·m).
4. Install the snap-on electrical box cover by pressing down firmly on all corners and install the screw, tight-
ening to 18 in-lb (2 N·m).
5. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.

FUSE

See General Warning, Section 10, Page 10-1.
Testing the Fuse
See Test Procedure 2, Section 11, Page 11-17.
Fuse Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Remove electrical component box cover.
3. Remove the fuse from the fuse block.
Fuse Installation
1. Install the fuse. See following WARNING.
ý
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before
installing a new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is
used, damage to the vehicle electrical system may occur.
2. Install the snap-on electrical box cover by pressing down firmly on all corners and install the screw, tight-
ening to 18 in-lb (2 N·m).
3. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.

KILL LIMIT SWITCH

See General Warning, Section 10, Page 10-1.
Testing the Kill Limit Switch
See Test Procedure 17, Section 11, Page 11-34.
Page 12-16 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
Fuse