Reverse Buzzer Limit Switch - Club Car FE350 2005 Maintenance Service Supplement

ELECTRICAL COMPONENTS
5. Install the bed or seat. See Section 5 – Body and Trim in the appropriate maintenance and service
manual.
AS SEEN
FROM FRONT
DRIVER SIDE
OF VEHICLE,
2
BODY
REMOVED
3
Figure 12-21 Front Reverse Warning Buzzer

REVERSE BUZZER LIMIT SWITCH

See General Warning, Section 10, Page 10-1.
Testing the Reverse Buzzer Limit Switch
See Test Procedure 20, Section 11, Page 11-36.
Reverse Buzzer Limit Switch Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Disconnect the wires from the reverse buzzer limit switch (4) located on the back of the Forward/Reverse
assembly (Figure 12-19, Page 12-19).
3. Remove the nuts (2) and washers (6) from the neutral lockout limit switch (5) and slide the neutral lockout
limit switch off of the screws. Do not disconnect the wires.
4. Remove the spacers (9) from the reverse buzzer limit switch (4) and slide the reverse buzzer limit switch
off the screws.
Reverse Buzzer Limit Switch Installation
1. Install the reverse buzzer limit switch (4), and then install two spacers (9) against the limit switch
(Figure 12-19, Page 12-19).
2. Install the neutral lockout limit switch (5) with two washers (6) and two nuts (2). Tighten to 5 in-lb (0.6
N·m). See following CAUTION.
ý
CAUTION
• Do not overtighten the retaining nuts. If the nuts are over tightened, limit switches could be
damaged.
M-
1
2
M+
2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
12
13
11
14
15
Figure 12-22 Rear Reverse Warning Buzzer
Reverse Buzzer Limit Switch
10
9
Page 12-21
12