Ignition Coil And Flywheel - Club Car FE350 2005 Maintenance Service Supplement

FE350 ENGINE
2. Install crankcase cover. Using HANDS ONLY, seat cover completely against the crankcase. If the cover
will not seat, the camshaft is not installed correctly.
3. Install and finger tighten evenly the eight cover mounting bolts (Figure 13-7, Page 13-7).
4. Tighten the cover mounting bolts in two steps. First, in the sequence shown, tighten all eight bolts to
approximately 130 in-lb (14 N·m). Then, repeating the sequence, tighten them to 250 in-lb (28.2 N·m).
5. Connect the yellow jumper wire (11) to the cord connector (12) (Figure 13-3, Page 13-5).
3
8
1
6
Figure 13-7 Crankcase Cover Installation

IGNITION COIL AND FLYWHEEL

See General Warning, Section 10, Page 10-1.
Ignition Coil and Flywheel Removal
1. Loosen three screws and remove the remaining four screws attaching the flywheel housing as shown,
then remove the housing (Figure 13-8, Page 13-7).
2. Disconnect the ignition coil (1) from its primary lead wire at the connector (2). Remove the two bolts (3)
and take out the ignition coil (Figure 13-9, Page 13-7).
Remove.
Figure 13-8 Flywheel Housing
5
7
2
4
Loosen.
Remove.
2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
Ignition Coil and Flywheel
2
1
Figure 13-9 Ignition Coil
13
3
Page 13-7