Main Jet Elevation/Size Chart; Changing The Main Jet - Club Car FE350 2005 Maintenance Service Supplement

14
FUEL SYSTEM

MAIN JET ELEVATION/SIZE CHART

ALTITUDE
0-3000 ft.
(0-914.4 m)
3000-5000 ft.
(914.4-1524 m)
5000-8000 ft.
(1524-2438.4 m)
8000-10,000 ft.
(2438.4-3048 m)
10,000 ft. and over
(3048 m and over)

CHANGING THE MAIN JET

See General Warning, Section 10, Page 10-1.
1. Remove the carburetor.
1.1. Turn fuel shut-off valve on fuel tank to the closed (OFF) position (Figure 14-16, Page 14-27).
1.2. Loosen the intake air hose clamp (22) and disconnect the intake air hose (23) at the carburetor end
only (Figure 14-1, Page 14-3).
1.3. Disconnect the governor cable (30) from the carburetor.
1.4. Disconnect the carburetor vent line (14).
1.5. Disconnect the fuel supply line (26) at the carburetor end only. Temporarily plug the end of the fuel
line to prevent fuel leakage.
1.6. Remove the carburetor retaining nuts (19), intake pipe (17), and carburetor (12). See following
NOTE.
NOTE: Note the orientation of the gasket (16), between the carburetor intake pipe (17) and the carburetor
body (12) so that it can be replaced in the same orientation (Figure 14-1, Page 14-3).
When removing the carburetor body, the throttle return spring (11) must be disconnected. Note its
proper orientation so that it can be replaced in the same orientation.
The carburetor must be kept upright during removal.
2. Position the carburetor with the drain screw (11) over a catch basin (Figure 14-2, Page 14-4).
3. Turn the carburetor bowl drain screw counterclockwise two or three turns and drain all the fuel from the
bowl into the catch basin (Figure 14-2, Page 14-4). Tighten the drain screw to 10 in-lb (1.1 N·m). Return
fuel to the fuel tank or dispose of properly.
4. Mark the body of the carburetor and the carburetor fuel bowl with an indelible ink marker so that, after
removal, the bowl can be installed again in the same position (Figure 14-2, Page 14-4).
5. Remove the carburetor fuel bowl retaining screw and washer (12), then remove the fuel bowl (10) and
clean it with a nonflammable solvent (Figure 14-2, Page 14-4). See following NOTE.
Page 14-2 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
FE350 ENGINE
MAIN JET SIZE
85
82
80
78
75
Carburetor