Ignition Coil - Club Car 2005 FE290 Maintenance Service Supplement

12
ELECTRICAL COMPONENTS
A
RPM Limiter Installation, Continued:
4. Connect black wire at the bullet connector to the white/black wire.
5. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.

IGNITION COIL

See General Warning, Section 10, Page 10-1.
Testing Ignition Coil
See Section 11, Test Procedure 13, Page 11-20, Test Procedure 14, Page 11-20, and Test Procedure
15, Page 11-21.
Ignition Coil Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Disconnect spark plug wire from the spark plug. See WARNING "To avoid unintentionally starting..."
in General Warning, Section 10, Page 10-1.
3. Remove the governor guard (1) (Figure 12-24, Page 12-25).
4. Remove the muffler. See Muffler Removal, Section 15, Page 15-1.
5. Cut the wire tie holding the wire harness to the stiffener (1) and remove the bolts (2) and nuts (3) securing
the stiffener to the mounting plate (4) (Figure 12-25, Page 12-25).
Page 12-24 2005 FE290 Gasoline Vehicle Maintenance and Service Supplement
DAMPER
RPM LIMITER
BROWN WIRE
BLACK WIRE
Figure 12-23 RPM Limiter Assembly
BLACK WIRE
TO IGNITION COIL
FEMALE BULLET
TERMINAL
Ignition Coil
FEMALE BULLET
TERMINAL
WHITE/BLACK
KILL CIRCUIT WIRE