Governor Cable - Club Car FE350 2005 Maintenance Service Supplement

14
FUEL SYSTEM
Accelerator Rod Installation and Adjustment, Continued:
10. Check rod adjustment for proper switch activation.
11. After the pedal group and accelerator rod are properly adjusted, adjust the engine RPM setting. See
Engine RPM Adjustment on page 14-11.
12. Install the electrical box cover and tighten retaining screw to 18 in-lb (2.0 N·m).
13. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.

GOVERNOR CABLE

Governor Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the
NEUTRAL position, and chock the wheels.
2. Access the engine compartment.
3. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
4. Disconnect the governor cable (2) at the carburetor throttle (Figure 14-1, Page 14-3).
5. Disconnect the governor cable (2) from the governor lever arm (15).
6. Remove the governor cable (2) from the governor cable engine bracket (11), and governor cable support
bracket (10) (Figure 14-1, Page 14-3). Remove the cable (2) from the vehicle.
Governor Cable Installation and Adjustment
1. Install the cable onto the governor cable support bracket (10) and the engine bracket (11) (Figure 14-6,
Page 14-9).
2. Push the cable dust shields onto the ends of the cable conduit.
3. Connect the governor cable to the carburetor throttle at the carburetor.
4. Connect the governor cable to the governor lever arm (15) (Figure 14-6, Page 14-9).
5. With the governor lever arm loose on the governor shaft, use a 1/8-inch punch or scratch awl to turn the
governor arm shaft counterclockwise until it stops. Then pull the governor lever arm rearward until the
carburetor throttle is in the "wide open throttle" (WOT) position.
6. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever nut
to 36 in-lb (4.0 N·m).
7. Check engine RPM adjustment. See Engine RPM Adjustment on page 14-11.
Page 14-8 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
Engine Control Linkage