Club Car FE350 2005 Maintenance Service Supplement page 131

FUEL SYSTEM
ý
CAUTION
• Be sure that approximately an equal number of threads are exposed at each end of the
accelerator rod.
6. Install the accelerator rod on the bell crank ball joint on the electrical component box (Figure 14-5,
Page 14-7). See following CAUTION and NOTE.
ý
CAUTION
• Inspect the limit switch inside the electrical box. If the limit switch lever is bent, replace the
switch.
NOTE: Use the inside hole location, or hole closest to the bell crank shaft as shown (Figure 14-5,
Page 14-7).
7. Before tightening the jam nuts, set the park brake to the first latch and pawl position and check for proper
activation of switches.
CAM
PARALLEL
RETAINING
WITH NUTS
BOX
Figure 14-4 Cam Position
8. While pressing the accelerator pedal, the following events should occur in exactly the order shown:
EVENT
Park brake release
Solenoid activation
Carburetor throttle actuation
9. While holding the accelerator ball joint with pliers, tighten the jam nuts against the ball joints, accelerator
ball joint first, at each end of the accelerator rod.
TOP VIEW OF THE
ELECTRICAL
COMPONENT
BOX
APPROXIMATE
PEDAL TRAVEL
0°-4°
4°-8°
8°-12°
2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
PULL SPRING RELEASE
TO INSTALL
ACCELERATOR ROD
BOTTOM VIEW
Figure 14-5 Accelerator Rod
14
Engine Control Linkage
3
Page 14-7