Club Car FE350 2005 Maintenance Service Supplement page 164

16
UNITIZED TRANSAXLE
Unitized Transaxle Removal, Continued:
4.9. Disconnect the engine oil level sensor wire (18-gauge yellow) at the connector just to the rear of the
starter/generator) (Figure 16-17, Page 16-10).
4.10. Disconnect the engine kill switch wire (18-gauge white/black) from the bullet connector at the lower
right front of the engine (Figure 16-18, Page 16-10).
4.11. Cut away the wire ties securing the engine kill wire at the lower right front of the engine (below the
exhaust header), the wire harness at the governor cable bracket, and the wire harness to the plate
beneath the muffler.
Figure 16-17 Oil Level Sensor Jumper Wire
5. Disconnect the brake cables.
5.1. Remove bow tie pin (1), brake cable clevis pin (2), and E-clip (3) (Figure 16-19, Page 16-10).
5.2. Remove the cable from the cable support bracket (Figure 16-19, Page 16-10).
AS SEEN FROM
DRIVER-SIDE OF
VEHICLE
Figure 16-19 Brake Cable
Page 16-10 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
STARTER/
GENERATOR
YELLOW
OIL SENDING
UNIT JUMPER
WIRE
2
4
3
1
REAR OF VEHICLE
WHITE/BLACK
WIRE
BLACK
WIRE
Figure 16-18 Ignition Kill Wire
Unitized Transaxle Removal