Club Car FE350 2005 Maintenance Service Supplement page 176

16
UNITIZED TRANSAXLE
Forward/Reverse Shifter Cable Installation, Continued:
5. Install the ball joint socket (2) on the Forward/Reverse shifter assembly ball stud (3) (Figure 16-53,
Page 16-22). See following NOTE.
6. Install wire tie (8) to secure wire harness to cable at the support bracket near the Forward/Reverse shifter
assembly. See following WARNING.
ý
WARNING
• If wires are removed or replaced, make sure wiring and wire harness are properly routed and
secured. Failure to properly route and secure wiring could result in vehicle malfunction,
property damage, personal injury, or death.
7. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.
32
Page 16-22 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
9
26
TURF 1 AND
CARRYALL 1
ONLY
27
28
24
8
7
31
CARRYALL 6, TURF 6,
VILLAGER 6, VILLAGER 8,
AND TRANSPORTER
VEHICLES ONLY.
Figure 16-53 Forward/Reverse Shifter Cable
3
2
1
4
5
5
Forward/Reverse Shifter Cable
10
11