Club Car FE350 2005 Maintenance Service Supplement page 167

UNITIZED TRANSAXLE
16. Place blocks under the engine pan so they will completely support the engine and keep it level to the
floor (Figure 16-28, Page 16-13). See following NOTE.
NOTE: Place the blocks so they will support the engine when the transaxle is detached and moved away
from the engine.
17. Remove the drive belt.
17.1. Grasp belt midway between drive and driven clutch and pull up on belt to force the driven clutch
sheaves apart. Roll the belt counterclockwise while pulling it off driven clutch (Figure 16-29,
Page 16-13).
Figure 16-28 Position Powertrain
18. Remove the driven clutch retaining bolt and remove the driven clutch from the unitized transaxle
(Figure 16-30, Page 16-13).
19. Loosen, but do not remove, the governor arm retaining bolt (1) (Figure 16-31, Page 16-13). Remove the
governor arm from the shaft. Do not disconnect cables.
Figure 16-30 Driven Clutch
ENGINE
PAN
DRIVEN
APPROX. 6
CLUTCH
INCHES
DRIVE CLUTCH
2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
Unitized Transaxle Removal
Figure 16-29 Remove Drive Belt
Figure 16-31 Governor Arm
16
1
Page 16-13