Club Car FE350 2005 Maintenance Service Supplement page 90

12
ELECTRICAL COMPONENTS
REVERSE WARNING BUZZER
See General Warning, Section 10, Page 10-1.
Testing the Reverse Warning Buzzer
See Test Procedure 21, Section 11, Page 11-36.
Front Reverse Warning Buzzer Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Remove the center dash panel. See Key Switch Removal on page 12-13.
3. Disconnect the wires from the reverse warning buzzer (2). Do not allow wires to touch (Figure 12-21,
Page 12-21).
4. Remove the mounting screws (3) securing the buzzer to the center dash.
Front Reverse Warning Buzzer Installation
1. Install the screws (3) through the buzzer bracket tabs and tighten to 3.5 in-lb (0.40 N·m) (Figure 12-21,
Page 12-21).
2. Connect the black wire from the key switch to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Reverse removal procedures to install the center dash in the vehicle. Be sure that the key switch termi-
nals cannot touch the frame and that the panel is properly seated and snapped in place.
5. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.
Rear Reverse Warning Buzzer Removal
For Turf 6, Carryall 6, Villager, and TransPorter vehicles:
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Remove the bed or seat. See Section 5 – Body and Trim in the appropriate maintenance and ser-
vice manual.
3. Disconnect the wires from the reverse warning buzzer. Do not allow wires to touch (Figure 12-22,
Page 12-21).
4. Remove the mounting screws (10) securing the buzzer (9) to the left rear fender.
Rear Reverse Warning Buzzer Installation
For Turf 6, Carryall 6, Villager, and TransPorter vehicles:
1. Install the screws (10) through the buzzer bracket tabs and tighten to a torque of 3.5 in-lb (0.4 N·m)
(Figure 12-22, Page 12-21).
2. Connect black wire (11) from frame ground to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.
Page 12-20 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
Reverse Warning Buzzer