Club Car FE350 2005 Maintenance Service Supplement page 120

13
FE350 ENGINE
Ignition Coil and Flywheel Removal, Continued:
3. Hold the flywheel (4), not the fan (7), with a strap wrench (5) and, using a 25 mm socket, remove the fly-
wheel nut (and flat washer) by turning it counterclockwise (Figure 13-10, Page 13-8). See following
CAUTION.
ý
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to
loosen.
• Do not damage the fan blades with the strap wrench. Do not place screwdriver or pry bar in
the fan blades.
4. Remove the flywheel with a puller (CCI P/N 1016627).
5. Remove the flywheel key from its groove.
4
Figure 13-10 Flywheel Nut
Flywheel Installation
See Flywheel Installation on page 13-9.
Ignition Coil Inspection and Repair
See Test Procedure 16, Section 11, Page 11-28.
Ignition Coil Installation
1. Installation is the reverse of removal.
2. While tightening the two bolts (3), use a bronze feeler gauge to adjust the ignition coil air gap to 0.012
inch (0.304 mm) (Figure 13-11, Page 13-8).
3. Tighten the two ignition coil bolts to 30 in-lb (3.4 N·m).
Crankcase Cover Installation
See Crankcase Cover Installation on page 13-6.
Page 13-8 2005 FE350 Gasoline Vehicle Maintenance and Service Supplement
5
7
3
0.012 INCH
(0.304 mm)
Figure 13-11 Adjust Ignition Coil Air Gap
Ignition Coil and Flywheel