Front Body; Front Body Removal; Front Body Installation - Club Car Precedent 2004 Maintenance And Service

BODY AND TRIM

FRONT BODY

See General Warnings, Section 1, Page 1-1.

FRONT BODY REMOVAL

1. Remove the four screws (2) and pull the brow cap (1) from the brow and fascia assembly (4) (Figure 4-1,
Page 4-4).
2. Pull the front beauty panel (3) up and away from the brow and fascia assembly (4), disengaging the snap
tabs.
3. If the vehicle is equipped with a canopy, loosen the canopy support cover then loosen, but do not remove,
the front canopy support bolts. If there is no canopy, remove the non-canopy cover.
4. Remove the five screws (8) and lift the brow and fascia assembly (4) from the front underbody.
5. Remove the five screws (7) to separate the front fascia (6) from the brow (5).

FRONT BODY INSTALLATION

1. Install fascia (6) to brow (5) with five screws (7). Tighten screws to 3.3 ft-lb (4.5 N·m).
2. Install brow and fascia assembly (4) to front underbody with five screws (8). Tighten screws to 1.8 ft-lb
(2.5 N·m).
2004 Precedent IQ System Golf Car Maintenance and Service Manual
4
Front Body
Page 4-3