Errors - Muratec MFX-1300/1700 Operating Instructions Manual

What you see on the
LCD
Too Many Steps
Unable to Reduce
Use FBS Glass
What it means/What to do
You tried to enter too many steps for a macro. You
can enter up to 60 steps into a macro key.
In the reduction copy using the , i f t h e
ADF
calculated ratio is smaller than minimum reduction
ratio (50%), this message will appear and you can-
not make the reduction copy.
Use the glass, however pa r ts of the image
FBS
might not be copied.
You tried to enlargement copy using the
Your machine cannot enlargement copy from the
. Please set your document on the
ADF
make the enlargement copy.

Errors

When sending faxes, your machine occasionally runs into communications errors. These
can be caused by anything from lightning to telephone line interference. (These same
factors cause the sta t i c , o r line noise, you sometimes hear on phone calls.) They also
can be caused by problems with the fax machine at the other end of the line.
Often, simply trying your call again is all that s necessary. However, if the problem per-
s i s ts regularly,call your local telephone company for help. If that doesn t help and the
problem persists regularly, call your authorized Muratec dealer.
Error reports
.
ADF
When an error occurs, your fax machine prints an error report. Each fax error report lists
glass to
an error message which includes:
FBS
A possible solution to the problem
The sending location (if the remote fax stores a Location
The r e s u l t which is a special error code.
A sample of the document s f i r s t page.
Kinds of error codes
The error code listed in the Result column of the error report indicates the specific
problem encountered:
codes Occur while dialing
D
codes Occur during reception
R
codes Occur during transmission
T
Specific errors
Following are some error codes you may see on an error report:
Dialing errors
. 0 . 3 , The remote unit didn t respond, the call couldn t be completed or
D
. 0 . 8 pressed during dialing. Re-try the call. If your machine repeats the message,
D
call the remote fax unit s operator and verify that unit is operating properly.
. 0 . 2 The remote unit is busy. Try the call again.
D
. 0 . 6 , Either the remote unit didn t respond, the call somehow didn t go through or
D
. 0 . 7 was pressed during dialing. Try the call again.
D STO P
Just in case
o f i ts own)
ID
was
STO P
5.9