Table of Contents
Advertisement
Changing the default settings
Settings for copying
Copy scan settings
Default setting: Primary document type: Text, Primary contrast: Normal
Two different settings tell your machine how to scan documents . The initial factory set-
tings are probably right for most applications, so try using them before changing any of
these settings:
Primary document type
Sets the document type for your documents. Choose
e i t h e r Te x t , Text&Photo, or Photo.
Primary contrast
Sets how light or dark you want copied documents to be.
Note: These primary settings you choose effect your copy activity only.
To set these modes:
1
Press Program key,
, 3 , 0 , 1 ,
B
Doc. Type:Text
/ /Enter
2
Press
o r
until the mode you want appears. In this example, we ve chosen
.
P H O TO
Doc. Type:Photo
/ /Enter
3
Press
to save the setting. The
ENTER
Contrast
:Normal
/ /Enter
4
Press
o r
until the mode you want appears. In this example, we ve chosen
light contrast.
Contrast
:Light
/ /Enter
5
Press
to save the setting.
ENTER
4.6
.The
asks you to select a resolution:
ENTER
LCD
asks you to select a contrast setting:
LCD
By following the steps above, you ve set your defaults for scanning. Before copying doc-
uments, you can override these default scan settings for that copying.
To override the default document type and contrast settings before copying a document:
Press
to change the document type.
D O C U M E N T
Press
to change the contrast.
CONTRAST
Once your document is copied, your machine returns to its default settings.
Adjusting the copy print settings
Default setting:
Margin: 24 mm
Your machine s print margin for copying is measured in millimeters (mm). Wel l d e f i n e
print margin by explaining how it s used:
When an original document is scanned, the machine measures the document s length
and compa r e s i t t o ( a ) the length of your selected paper (not include the print margins)
plus (b) the print margin you set. If the length of the document is longer than ( a ) and ( b )
put together, your machine prints the document on more than one sheet.
Note: A print margin setting of 24 mm will print most documents as single pages. Tr y
this combination first and then, only if you have problems with it, select different
settings.
1
Press Program key,
, 3 , 0 , 2 ,
B
ENTER
copying:
Margin
(00-85mm):24
2
Use the numeric keypad to enter the print margin you want. If necessary, press
o r
to move the cursor. In this example, we ve chosen 20mm.
Margin
(00-85mm):20
3
Press
to save the setting.
ENTER
.The
shows the current print margin for
LCD
Advertisement
Chapters
Table of Contents
