Muratec MFX-1300/1700 Operating Instructions Manual page 105

Advanced features
Important: While in Mode 1, any autodialer numbers you use must include the
PIN
.This also applies to autodialer numbers used with batch transmission
PIN
(see page 3.11) or programmable one-touch keys (see pages 3.35 3.48).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission, you
must store the access code for the remote unit within the appropriate batch
PIN
box.
If you chose Mode 2 as you autodial, load the code
In this mode, you don t have to add the
t h e manually each time you autodial:
PIN
1
Dial the number as you normally would, using the autodialer. Here, we ve pushed
one-touch key . The machine now asks for the
A
Enter PIN Number
_
2 Use the numeric keypad to enter the
Enter PIN Number
1057_
3 Press .Your machine dials the number.
STA R T
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission (see
page 3.11), you must store the
appropriate batch box.
Dialing from the numeric keypad while using the
If you ve specified Mode 1 use star power
1 Enter the phone number, then press the *(s tar ) key and enter the
The always goes last. For example, to dial 19725550911 with a
PIN
enter 19725550911*123456:
Press Start
19725550911*123456_
2 Press .The disappears from the display, and your machine dials the
STA R T PIN
desired phone number.
3.52
to the autodialer setting. Instead, you enter
PIN
:
PIN
.
PIN
access code for the remote unit within the
PIN
mask
PIN
PIN
of 123456 ,
PIN
If you ve specified Mode 2 the machine guides you
1 Enter the phone number as usual.
Press Start
19725550911_
2 Press
STA R T
Enter PIN Number
_
3 Use the numeric keypad to enter the
Enter PIN Number
123456_
4 Press
STA R T
Performing batch transmission while using the
Note: The following instructions presume you are familiar with how to set and use
both your machine s autodialer and its batch transmission feature. If you need
to review, see pages 3.1 3.8 for more on the autodialer and/or page 3.11 f o r
more on batch transmission.
If you ve specified Mode 1 or Mode 2
Important: Any autodialer number you use with batch transmission must include the
. ( To review how to include this information in an autodialer number,
PIN
review the Mode 1 instructions under Autodialing while using the
mask, page 3.51.)
Before sending a batch transmission the first time, you must store the
batch box.Here s how:
.
1 Follow the steps for creating or modifying a batch box (pages 3.11 3.12).
The asks for the fax number (here, we re working with batch box 1):
LCD
1:Fax Number
_
2 Enter an autodialer number, or use the numeric keypad to enter the fax number,
to which the batch transmission should go.
Important:
.The shows:
LCD
.
PIN
.Your machine dials the number.
If you re entering a number from the numeric keypad, enter the fax
number, followed by the *(s tar ) key and then the
mask
PIN
PIN
w i t h i n i ts
PIN
.
PIN