Muratec MFX-1300/1700 Operating Instructions Manual page 95

Advanced features
18 Press . The asks you to select a contrast mode for each programmable
ENTER LCD
one-touch number.
Contrast :-------
/ /Enter
19 Press until the mode you want appears.
20 Press . The asks if you want the memory transmission on or off when
ENTER LCD
using this programmable one-touch number.
Memory Tx
/ /Enter
21 Press until the mode you want appears.
22 Press . The asks you for the type of confirmation report you want to set
ENTER LCD
for this programmable one-touch number.
Report
/ /Enter
23 Press until the mode you want appears.
24 Press . The asks if you want to send a cover page for this programma-
ENTER LCD
ble one-touch number.
Cover Page
/ /Enter
25 Press until the mode you want appears.
26 Press . The asks if you want to turn the Fax & Copy feature on or off f o r
ENTER LCD
this programmable one-touch number.
Fax & Copy
/ /Enter
Note: When the memory transmission is set to off in step 20, this
appear and go to step 29.
27 Press until the mode you want appears.
28 Press .
ENTER
29 Press to return your machine to standby mode.
STO P
3.42
:---
:---
:---
:---
Programming F-Code polling
For this operation to work, two things must be true:
The document which you re polling must exist in the remote fax s F-Code box (
s tandard sub-addressing/password box).
You must know the remote fax s
box you want to poll.
To program an F-Code polling operating into a programmable one-touch key:
1 Press Program key,
ble one-touch number available:
Select Program No.
P2:No Number Stored
Note: I f P2 appears on the
b e r f o r P1. You can see what you programmed into P1 by pressing
you want. For example, if you set P1 for storing of the polling document,
you will see:
Press
enter.
Note: To erase a programmable one-touch key, see page 3.48.
2 Press the key that you want to program or change. Here, we ve selected P2.
Select Program No.
P2:No Number Stored
Note: If your previous command for this key was for an F-Code polling opera-
tion and you want to keep this key programmed for an F-Code polling
operation, use these instructions to make changes. But if you want to
assign this key to a completely different operation (for a delayed trans-
mission, for example), then you first must erase the stored command
before programming the new one.
w i l l n o t
LCD
3 If you want to select a different programmable one-touch key than the one that
appears on the
4 Press
ENTER
grammable one-touch:
Type :Communication
- sub-address and password (if any) for each
ITU T
, 3 , 0 , 1 , .The
A ENTER LCD
, it means that you have already entered a num-
LCD
Select Program No.
P1:Polling Document
to go back to the programmable one-touch key you want to
, press that key now.
LCD
.The asks which operation you want to program into the pro-
LCD
/ /Enter
-
ITU T
shows the first empty programma-
, i f