Sending A Fax Using The Adf - Muratec MFX-1300/1700 Operating Instructions Manual

Basic operation
Sending a fax using the
1 Press / to change to Fax mode.
C O P Y FA X
2 Insert the document face up, top edge first. And adjust the document guides
by sliding either of them to the left or right to fit the page(s) you ll be faxing.
Your fax machine s (Automatic Document Feeder) will hold up to 50 pages
ADF
with letter-sized paper.
When a document is in the feeder, t h e
the Glossary beginning on page 5.17) and the amount of memory available:
Document Ready
A4 Mem100%
3 Adjust resolution and contrast if necessary.
4 Enter the fax number.
Also, enter any access codes necessary, just as you would for a regular phone
call. (Example: Enter 9 to dial out from an office telephone system, or 1 for long-
d i s tance.)
Press Start
919725552009_
5 Press .
STA R T
By pressing , you ve just given your machine a command. In turn, your
STA R T
machine gives this action a command number as it scans the fax document.
This command number appears on the first line of the
== Command:01 ==
You ll need to know this command number if you later wish to cancel the trans-
mission or to print a stored document (see pages 2.7 2.8).
2.4
ADF
shows the scanning width (see
LCD
for a few seconds:
LCD
6 Now, everything is up to the machines yours and the one you re dialing.
If the fax has been set for Quick Memory transmit, your machine scans the
f i r s t page of your document into memory, then dials the other fax. When it
makes contact, your machine transmits the stored document from memory
while at the same time scanning the remaining pages of your document into
memory. (In default setting, the Quick Memory transmission i s O n. If you want
to turn off this feature, see page 4.2.)
If the fax has been set for the normal memory transmit, your fax scans the
entire document into memory, then dials the other fax. When it makes conta c t ,
your machine transmits the entire stored document from memory.
I f t h e f a x i s s e t f o r Real time transmit (non-memory transmission), your
machine simply dials the other fax. When it makes contact, your machine
feeds the document through, scanning and transmitting it as it goes.
Note: The more stuff ( c a l l e d black coverage) your machine sees on a page,
the more slowly the page feeds through as the fax scans it. And even if
the page is relatively clean, sending it in grayscale mode or at certa i n
resolutions makes your machine see more stuff .
The same is true if you set the contrast to Dark.
4 i n
A
Important: If you want to cancel a transmission while scanning the document,
press the
If you want to cancel a transmission in progress, use the Review
Commands function. See Reviewing or canceling commands,
page 2.7.
7 At the end of the operation, your fax machine beeps and displays:
919725552009
** Complete
Important: Whenever you transmit a document, what actually appears on the
top line of the display depends on information stored in the remote
f a x . The line may even be blank.
Note: If the call fails, see Redialing, page 2.6.
key.
STO P
**