Muratec MFX-1300/1700 Operating Instructions Manual page 127

Just in case
Printouts have irregularities
ABCDE
The paper you re using may have absorbed moisture, per-
haps due either to high humidity or water having been spilled
ABCDE
on the paper supply. Toner will not adhere well to wet paper.
ABCDE
Replace the paper with dry paper and try printing again.
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
ABCDE
Using the cleaning paper, gently clean the LED print head.
The charger may be dirty.
Your machine normally cleans the charger automatically.
If other solutions fail, please contact your authorized Muratec
dealer.
5.4
Printouts have white and/or black
l i n e s
The toner cartridge or drum cartridge
may be defective.
Remove the cartridges and check them for
damage.
If the problem persists, replace either or both
of the cartridges as indicated.
The LED print head may be dirty.
Printouts have toner smudges
ABCDE
The toner may be unevenly distributed inside the toner car-
t r i d g e .
ABCDE
Remove the toner cartridge and shake it a few times to redis-
ABCDE
tribute the toner inside. If the problem persists, replace the
cartridge.
ABCDE
The toner cartridge or drum cartridge may be defective.
ABCDE
Remove the cartridges and check them for damage. If the
problem persists, replace either or both of the cartridges as
indicated.
If you find smudges on the back of the printouts, the transport
roller may be dirty.
Your machine normally cleans the transport roller automati-
c a l l y. If other solutions fail, please contact your authorized
Muratec dealer.
Printouts have white spots
ABCDE
The charger may be dirty.
Your machine normally cleans the charger automatically.
ABCDE
If other solutions fail, please contact your authorized Muratec
ABCDE
dealer.
ABCDE
ABCDE