Settings For Transmission; Scan Settings - Muratec MFX-1300/1700 Operating Instructions Manual

Settings for transmission

Scan settings

Default setting: Primary resolution: Normal, Primary contrast: Normal
Two different settings tell your machine how to scan documents . The initial factory set-
tings are probably right for most applications, so try using them before changing any of
these settings:
Primary resolution mode Sets the resolution for your documents. Choose either
normal, fine, superfine ( S Fine on the
Primary contrast mode Sets how light or dark you want faxed documents to be
when they arrive at their destinations.
Note: The primary settings you choose effect your fax activity only.
To set these modes:
1 Press Program key, , 2 , 0 , 1 ,
B ENTER
Resolution :Normal
/ /Enter
2 Press o r until the mode you want appears. In this example, we ve chosen
fine resolution.
Resolution :Fine
/ /Enter
3 Press to save the setting. The
ENTER
Contrast :Normal
/ /Enter
4 Press o r until the mode you want appears. In this example, we ve chosen
light contrast.
Contrast :Light
/ /Enter
5 Press to save the setting.
ENTER
) or grayscale mode ( Gray ).
LCD
.The asks you to select a resolution:
LCD
asks you to select a contrast setting:
LCD
By following the steps above, you ve set your defaults for scanning. Before sending doc-
uments, you can override these default scan settings for that transmission.
To override the default resolution and contrast settings before sending a document:
Press to change the resolution.
RESOLUTION
Press to change the contrast.
CONTRAST
Once your document is transmitted, your machine returns to its default settings.
Setting
E C M
Default setting: O n
Line noise, o r s tatic on the line during a call, can easily disrupt the flow of data from
one fax machine to another.
That s why your fax machine gives you the option of using Error Correction Mode (
When two fax machines communicate while running in
matically checks the data as it sends. If the receiving fax machine can t verify the
transmission, the first machine will re-send it as necessary.
Note: gives you a better chance of transmitting a fax document over a bad phone
E C M
line, but it could also slow down the transmission time. And the worse the line
is, the slower the transmission. That s why the machine lets you turn
o ff as needed.
Note: Not all fax machines have .If you ve activated
E C M
fax machine not currently using
E C M
sion from a usual, non- transmission.
E C M
1 Press Program key, , 2 , 0 , 9 ,
B ENTER
ECM Mode :On
/ /Enter
2 Press o r until the mode you want appears.
In this example, we ve chosen O f f .
ECM Mode :Off
/ /Enter
3 Press to save the setting.
ENTER
Changing the default settings
E C M
, the sending machine auto-
E C M
on or
E C M
and then transmit to a
E C M
, there will be no change in the fax transmis-
.The shows the current setting:
LCD E C M
) .
4.1