Muratec MFX-1300/1700 Operating Instructions Manual page 90

17 Press . The asks you for the type of confirmation report you want to set
ENTER LCD
for this programmable one-touch number.
Report :---
/ /Enter
18 Press until the mode you want appears.
19 Press . The asks if you want to send a cover page for this programma-
ENTER LCD
ble one-touch number.
Cover Page :---
/ /Enter
20 Press until the mode you want appears.
21 Press . The asks if you want to turn the Fax & Copy feature on or off f o r
ENTER LCD
this programmable one-touch number.
Fax & Copy :---
/ /Enter
Note: When the memory transmission is set to off in step 15, this
appear and go to step 24.
22 Press until the mode you want appears.
23 Press .
ENTER
24 Press to return your machine to standby mode.
STO P
Programming a broadcast / group
Programming a broadcast is very similar to programming a delayed transmission. But
instead of sending to just one phone number, you set up multiple numbers for the trans-
mission.
To program a broadcast / group into a programmable one-touch key:
1 Press Program key,
ble one-touch number available:
Select Program No.
P2:No Number Stored
Note: I f P2 appears on the
b e r f o r P1. You can see what you programmed into P1 by pressing
you want. For example, if you set P1 for storing of the polling document,
you will see:
Press
enter.
w i l l n o t
LCD
Note: To erase a programmable one-touch key, see page 3.48.
2 Press the key that you want to program or change. Here, we ve selected P2.
Select Program No.
P2:No Number Stored
Note: If you re changing a previously stored command: If your previous com-
mand for this key was a for a broadcast/group transmission, and you
want to keep this key programmed for a broadcast/group transmission,
use these instructions to make changes. But if you want to assign this
key to a completely different operation for batch transmission, then you
must first erase the stored command before programming the new one.
3 If you want to select a different programmable one-touch key than what appears
on the
LCD
4 Press
ENTER
grammable one-touch:
Type :Communication
Note: If changing a previously stored command, skip to step 7.
, 3 , 0 , 1 , .The
A ENTER LCD
, it means that you have already entered a num-
LCD
Select Program No.
P1:Polling Document
to go back to the programmable one-touch key you want to
, press that key now.
.The asks which operation you want to program into the pro-
LCD
/ /Enter
Advanced features
shows the first empty programma-
, i f
3.37