Caring For Your Fax Machine; Corrective Cleaning - Muratec MFX-1300/1700 Operating Instructions Manual

Just in case

Caring for your fax machine

W ith proper installation and a little maintenance, your fax machine should give you
dependable service for years to come.
Although it requires little day-to-day care, you can take these simple precautions to
keep it in top form:
Always make sure your fax machine is installed according to our specifications,
including using an electrical surge suppressor. (If necessary, review Pick an insta l l a-
tion spot, page 1.5.)
Always use good, copier-quality paper.
Always clean your fax machine as needed (see Cleaning tips, below).
Never i n s tall your fax machine where it can overheat, gather dust or get splashed by
any liquids (even water).
Cleaning tips
Some things to keep in mind about cleaning your fax machine:
D o clean it! Dust and dirt, especially around the fax machine s air vents can shorten
your machine s l i f e .
Always unplug the fax machine before you clean it.
Never spray any cleaner
DIRECTLY
damage components inside.
Never try to clean areas inside your fax machine. They re sealed to pro-
SEALED
tect your safety and the machine.
For cleaning external surfaces, such as the cover and handset: use a mild cleaning
solution sprayed onto a lint-free towel or cloth.
Always use a lint-free cloth (or swabs) moistened with alcohol to gently wipe compo-
nents inside your machine.
In areas you can t reach with swabs, always use dry, dust-free compressed air to
gently blow away dust and other material.
5.12
onto your fax machine. The drifting spray could

Corrective cleaning

Here are some simple cleaning procedures for keeping your fax machine operating
smoothly. Use each as the need arises.
Curing frequent jams in the
ADF
If you re having trouble with getting your original documents to feed properly, t r y t h i s
procedure:
1 Turn off your fax machine.
2 Get two soft, lint-free cloths and moisten them as follows:
One with a cleaner suitable for use on platen/rubber rollers. In steps 4 and 6,
we ll call this the rollers cleaner.
The other with isopropyl alcohol
3 Open the scanner cover by holding the scanner cover release.
Important: You must hold the cover open. It won t stay open by its e l f .
4 Use the cloth with the rollers cleaner to clean the face of the rollers. Rotate the
rollers by hand to allow cleaning of the entire roller surface.