Ricoh FT5535 Service Manual page 99

Hide thumbs Also See for FT5535:

Table of Contents

2.7 SP5-019 PAPER SIZE SETTING

2.7.1 Paper Size Selection for the Paper Tray Unit, LCT, and By-pass Feed

For the paper tray unit, LCT and by-pass feed, the paper size can be selected

with SP5-019 using the following procedure.

1. Enter SP mode as follows;

1) Press the "Clear Modes" key.

2) Enter "107" with the numeric keys.

3) Hold down the "Clear/Stop" key for more than 3 seconds.

NOTE: When SP mode is selected, "1" blinks in the 3rd digit of the copy

counter, the Auto Image Density indicator starts blinking, and the

reduce/enlarge indicator turns off.

2. Enter SP5-019 as follows

1) Enter "5" and press the "Enter" key.

2) Enter "019" and press the "Enter" key.

3. Press the

3rd level (001~008

can be selected with

Example: In an A155 copier, to select the paper size for the LCT, select 3rd level

program 007.

The 3rd level program number is blinking in the 1st digit of the

copy counter.

Depending on the 3rd level program number, the paper tray

indicator changes.

SP settings for each 3rd level program number are blinking in the

reduce/enlarge indicator.

*SPECIAL: See section 2.7.2 "Special Paper Size Selection for the 1st Tray".

FT5535/4527/4522

key until the required 3rd level program number is

A153/A157 copiers

A155/A159 copiers

A156/A160 copiers

Show Quick Links

Table of Contents

Ft5035 Ft4022 Ft4527 Ft4027 Ft4522