⇒
Fiber Connector Plug [P]
8. Install the sorter [A] on the sorter holder bracket [B] (1 snap ring) as shown.
⇒
9. Remove the Plug [P] from the rear of the copier.
10. Connect the connector [C] to the socket [D] on the rear side of the copier.
11. Plug in the copier power cord and turn on the main switch.
12. Press the following sequence of keys to enter SP mode.
→
NOTE: (1) Hold the last
(2) Upon entering SP mode, "1" blinks in the 3rd digit of the copy
(3) The above procedure must be finished within 20 seconds.
13. Press the following sequence of keys to change the "SP6-101" value to "1".
→
→
14. Turn the main switch off and on.
15. Check the sorter's operation.
FSM
[B]
[D]
[C]
→
counter, the Auto Image Density indicator starts blinking and the
reduce/enlarge indicator turns off.
→
→
→
key for more than 3 seconds.
→
→
13-7
Rev. 10/11/95
[A]
→
FT5535/4527/4522