Ricoh FT5535 Service Manual page 384

Tech Service Bulletin No. 4027/4527/5035/5535 - 006
Page 4 of 8
18. Replace the one way clutch AA083011 [ P ] with AA083009
Upper Unit [ Q ]......2 pcs.
Lower Unit [ R ]......1 pc.
19. Reassemble the both feed units. Please refer to the drive belt layout for belt routing [page 6.].
[ Q ]
For the FT5535
1. Remove the by-pass feed table [ A ]
(1 clip, 1 connector).
2. Remove accessory connectors from
rear of machine.
3. Remove the rear cover.
4. Remove the harness cover [ A ]
(1 screw).
5. Remove the LCT's rear cover [ B ]
(2 screws).
6. Remove the stopper bracket [ C ]
(1 screw).
7. Disconnect five connectors [ D ] and
remove the harness bushing [ E ].
8. Remove the LCT.
[ R ]
[ P ]
The Feed Roller Shafts must also be
replaced if the clutch [P] is locked.
Please refer to page 7 and 8 for the
Paper Feed Drive Roller and the Feed
Roller Shaft Replacement Procedures.
[ P ]
[ D ]
[ B ]
[A]
[ E ]
[ A ]
[ C ]
Continued...